How to buy tiles so that you will not be deceived

　　 When we buy ceramic tiles, we are often confused. How can we test the quality of ceramic tiles? The editor summarizes five steps, which may help you, how to distinguish good tiles from bad? Next, let us work together to teach you how to buy ceramic tiles so that you will not be deceived?

　　 The first step: look at the water absorption rate of the tiles.　　 Pour some mineral water on the front and back sides of the tiles, carefully observe the water penetration, after ten minutes, if the water has not been absorbed, it means that you have a good eye for the tiles and you have selected high-quality tiles.　　 Step 2: Look at the flatness of the tiles 　 　 The flatness of the tiles is not good, and the tiles will be warped after they are laid out later. For the lighter, you may knock off the warped tiles and re-apply them. For the worst, you may have to knock all the tiles off and buy again. Therefore, when buying ceramic tiles, you must distinguish whether the surface of the ceramic tiles is flat or not. Put two tiles of the same style together to see if there is a gap between them.　　The third step: look at the straightness of the corners of the tiles. 　　The straightness of the corners of the tiles will also affect the later paving and use of the tiles. If the corner is not a right angle, there will be a big gap between the tile and the tile, and a lot of jointing agent will be used to joint, and the effect will be very ugly. It is similar to the identification of flatness. Use two tiles of the same style to form a quadrilateral, and see if the gap in the middle is big. Step 4: Look at the stain resistance of the tiles to do this anti-fouling test is very simple, just use an oil-based pen, write a few words on the surface of the tile, wait a while for the ink to dry, and then wipe it with a rag or paper towel to see if Easy to clean off. Step 5: Look at the degree of wear resistance of ceramic tiles. In recent years, ceramic tiles have undergone a series of innovations in wear resistance. Whether it is polished tiles, microcrystalline stones, fully polished glazes, antique tiles, etc., there is a quality leap. So how to judge whether the tile surface is wear-resistant? You can use a tool such as a key to scratch the surface of the tile.　　 teaches you how to buy tiles so that you will not be deceived, so I will introduce it here. If you want to know more about tiles, you can click on the tile brand to learn more.